Weanas Solar Fountain Pump, Solar Powered Floating Fountain Kit With Battery Backup Solar Water Fountain for Bird Bath Pond, Pool and Garden Decoration

April 22, 2018 - Comment

【Specification】 ★ Battery power: 10V, 1.5W ★ Size of solar panel: 180*25mm ★ Battery type: rechargeable Li-ion, 7.4V, 600mAh ★ Pump power: 7V, 1.1W ★ Max flow of pump: 160L/h ★ Max lift of pump: 100cm ★ Max water height: 30-50cm 【Tips】 ★ The fountain works while it’s receiving direct sunlight. Please make sure the

Buy Now! $15.99Amazon.com Price
(as of 22. July 2018 17:51 CEST - Details)

【Specification】
★ Battery power: 10V, 1.5W
★ Size of solar panel: 180*25mm
★ Battery type: rechargeable Li-ion, 7.4V, 600mAh
★ Pump power: 7V, 1.1W
★ Max flow of pump: 160L/h
★ Max lift of pump: 100cm
★ Max water height: 30-50cm

【Tips】
★ The fountain works while it’s receiving direct sunlight. Please make sure the solar panel is under bright and unblocked sunlight.
★ It is recommended to install the tubes and nozzles after the fountain starts spraying water. The nozzle top should be above the water.
★ If your fountain stops working, you can move it to a shaded area to cool down. Then you have 2 ways to reset it. You can charge it under the sun outside of water for 2 hours. Alternatively, you can tap the center of the solar panel or gently knock it to reset it.
★ Water should at least 1 inch (2.5 cm) deep and clean. If water is not deep enough, the pump is not able to pump in and spray out water.
★ Clean the container and the pump regularly. Too much dirt may block to pump.
★ Certain parts may differ in different models of fountains. Please contact seller if you have question.

【Cautions】
1.Do not put the fountain under sunlight without water for too long
2.Do not use the fountain in dirty or corrosive water. Change the water regularly.

【Installation】
1.Insert part H(short tube) to the port in the center of the solar panel.
2.Insert part G(long tube) on part H.
3.If you are using nozzle B, insert it on part G directly.
4.If you are using the nozzle C, D, or E, install it on part F and then insert on part G.
5.You can also skip part G and insert the nozzles directly on part H.
6.Put the fountain in water, with the pump completely under water and nozzle above water.

Comments

Write a comment

*